1600 degree touch screen laboratory high temperature heat treatment degreasing and dewaxing furnace
Leave a message
The development of a 1600°C touchscreen laboratory high-temperature heat treatment degreasing and dewaxing furnace marks a new era in intelligent specialty ceramic sintering technology. When the furnace temperature exceeds the critical 1500°C, its multi-layer gradient temperature control system begins to demonstrate its unique advantages.
During the sintering process of ceramic substrates, the system uses distributed infrared sensors to capture real-time changes in the material's crystal phase and dynamically adjust the power output of six independent heating zones. Engineers have found that when the furnace pressure is maintained at a vacuum of 10^-3 Pa, the dewaxing rate of the zirconia blank is increased by 37% compared to a traditional nitrogen environment, and the surface porosity is reduced to below 0.2%. The three-dimensional thermal map displayed on the touchscreen clearly shows that at the constant temperature of 1580°C, the internal stress distribution of the blank exhibits a perfectly symmetrical gradient, which is the key to preventing warping and deformation in multi-layer co-fired ceramics.
Even more surprising is the "thermal barrier effect" created by the furnace's composite fiber insulation layer and active water cooling system. Test data shows that even under extreme operating conditions, the furnace shell temperature remains below 65°C, fully meeting laboratory safety standards. During a 48-hour high-entropy ceramic sintering experiment, the system automatically triggered the trace oxygen compensation mechanism three times, successfully repairing silicon nitride lattice defects and ultimately achieving a dense sintered body with a flexural strength of 820 MPa.
The 1600°C Touchscreen Laboratory High-Temperature Heat Treatment Degreasing and Dewaxing Furnace is a high-temperature laboratory equipment primarily used for material degreasing, dewaxing, and high-temperature heat treatment processes. The following is an introduction to its features and applications:
Main Features:
High-Temperature Performance: Operating temperatures reach up to 1600°C, with a continuous operating temperature of 1550°C, meeting a variety of high-temperature processing requirements.
Touchscreen Control: Equipped with a large, intuitive touchscreen interface, users can easily set temperature curves, monitor real-time temperatures, and record experimental data, improving operational convenience and experimental efficiency.
Temperature Control: Utilizing PID control technology, the temperature control accuracy reaches ±1°C, and 16/32/40 programmable temperature control steps are available. This allows for controlled heating processes, ensuring accurate and repeatable experimental results.
Heating Elements: Silicon-molybdenum rods are typically used as heating elements, offering high-temperature resistance and excellent oxidation resistance. They operate stably at high temperatures, ensuring equipment reliability.
Insulation: The furnace chamber is constructed of imported ceramic fiber material, which is resistant to high temperatures and rapid heating and cooling, offering excellent insulation properties, effectively reducing heat loss and lowering energy consumption.
Safety: Multiple safety mechanisms, including over-temperature alarms, automatic power-off protection, and a furnace door safety lock, ensure the safety of both laboratory personnel and equipment.
Applications: Primarily used in research institutes, industrial and mining enterprises, and for integrated debinding and pre-sintering of ceramic components. It can also be used for debinding, pre-sintering, and sintering of ceramic powders, magnetic materials, and electronic components.
With the performance testing of batches of specialty ceramic components complete, the R&D team has set its sights on more advanced applications. By implementing an AI temperature prediction algorithm, the furnace can autonomously learn the sintering curves of different materials. In a recent experiment with functionally gradient materials, the system completed the entire process, from debinding to sintering, in just 60% of the preset time, reducing energy consumption by 22%. This highly adaptable and adaptable equipment is redefining the industry standard for high-temperature material processing.








