Analysis of Terminal Machine Manufacturers on the Reasons for Overheating of Automatic Terminal Machine Bearings

Analysis of Terminal Machine Manufacturers on the Reasons for Overheating of Automatic Terminal Machine Bearings

 

 

 

The fully automatic terminal machines produced by terminal machine manufacturers are capable of cutting, peeling, and pressing wires, similar to computer wire stripping machines, and have functions for peeling and pressing detection. There are mechanical terminal machines (mostly domestically produced) and computer terminal machines (joint venture and imported) on the market.

 

 

 

 

 

The computer style uses track motion and servo motor operation, with excellent stability and accuracy, but the price is around 12W (single head) -23W (double head). Mechanical transmission involves mechanical transmission, with a certain scale of stability and accuracy. But there is a discount on the price, which is around 60000 (single head) to 120000 (double head).

 

 

 

 

 

There are many reasons that can cause the bearings of fully automatic terminal machines to overheat, among which there are several common reasons. Let's take a look below. The imbalance of the inner and outer rings of steel ball bearings is one of the reasons for heating. The imbalance of the inner and outer rings of the terminal machine may be caused by machining. Because the base and end cover of the fully automatic terminal machine are processed separately, sometimes there may be bearing holes on the two end covers that are not coaxial (i.e. the centerline is not on the same line). In addition, poor assembly, uneven tightening of screws on the end cover, and dust and dirt on the stop may also cause imbalance between the inner and outer rings.

 

 

 

 

 

If the inner and outer rings of the bearing are unbalanced, it will cause the steel balls and inner and outer rings to scrape, increasing friction and heating. If there are no other reasons found, clean the machine mouth and reinstall it, and tighten the screws one by one in diagonal order. The small amount of error formed during processing can be improved by gradual automatic adjustment. Tight belts or fully automatic terminal machines that are not aligned with the axis center of the driven machinery, i.e. not concentric, can increase the bearing load and generate heat.

 

 

 

 

 

The daily maintenance method of the fully automatic terminal machine from the terminal machine manufacturer: 1. (Stepping principle) The motor is constantly rotating. There is a circuit breaker with a clutch inside, and every time it moves, a standard "O" comes out, which is common. 2. In the past five years, there has been a (silent) terminal machine with a server, which operates differently from the above. It only provides a message to the server, which is then transmitted to the motor to form an action.

 

 

 

Www.superbheater.com