Common faults and maintenance methods of dry cleaning machine equipment?

Many people simply believe that dry cleaning is a low-tech industry with low barriers, and anyone can do it. However, this is not the case. Dry cleaners are a relatively technical industry, and you will encounter many technical problems during the process of opening a store.
Common failures of dry-cleaning machines. Generally speaking, new dry-cleaning machines do not have mechanical failures. However, you need to know that it takes several years or even longer for a dry-cleaning shop to open. During this process, it is inevitable that some major and minor failures will occur. At this time, you need to contact your service provider and ask them to provide you with technical assistance. Generally speaking, your service provider will first help you understand the general situation of the fault through remote communication, including the time of the fault occurrence, the specific situation of the fault, the approximate location of your dry cleaning shop, and so on.
Generally speaking, the most likely faults encountered are the following:
First, it is difficult to increase the drying degree;
Secondly, the drying time is too long;
Third, the filter element is clogged and the filtering effect is poor;
Fourth, the dry cleaning machine does not apply or discharge liquid;
Fifth, the compressor will alarm and shut down less than one minute after being turned on;
During the sixth distillation, the temperature does not rise, the cleaning solvent cannot purify or the purification effect is poor;
The seventh oil water separator failed, causing water in the washing solvent to affect recovery.
In addition, steam generators are also a frequently malfunctioning device.
You may need to know the following three types of faults:
"The steam generator does not have enough liquid on it, which means that in addition to steam injection, a large number of water droplets or mist are splashed out with the steam. This may be caused by the reverse rotation of the water pump motor or the unclosed drain valve;";
2. The heating key may not be turned on or there may be a problem with the heating key circuit after adding water;
There is no steam. At this time, it is necessary to check the rear cover or steam output valve of the steam generator to see if it is open.

The above content is organized by Superb heater Company, super heater. Mainly professional production: industrial heating elements, temperature measuring elements, production equipment, accessories, and raw materials such as tubular heaters, tubular heaters, belt heaters, ceramic heaters, silicone rubber heaters, thermocouples, etc.

Welcome global industry partners to discuss cooperation!