Describe the possible problems and solutions of microwave drying equipment

Traditional drying methods take a long time, consume a large amount of electricity, heat unevenly, have a high labor intensity, and flip up and down. However, microwave drying features that microwave energy can penetrate the inside and outside of an object while heating at a frequency of 2450 MHZ, oscillating at 2.45 billion times per second. Water molecules also oscillate at 10000 times, causing heat to be generated by friction between molecules, resulting in their own heating. Therefore, it can be widely used for drying and dehydration of packaged materials of chemical products.
Possible problems and solutions of microwave drying equipment:
1. The transmission belt of the microwave drying equipment is stopped or abnormal, perhaps due to the steady burning of the governor, which can be replaced safely; After that, check whether the motor is burnt out, and if so, replace the motor; If the reducer is abnormal, it needs to be repaired
2. The fan of the microwave drying equipment does not work or has abnormal sound, perhaps due to a three-phase power supply phase failure. Check and clean it; Or maybe the fan blades hit the casing, which is the need to repair the fan blades
3. When the microwave of the microwave drying equipment cannot be applied, the temperature switch may be damaged or the contactor wire package may be burnt out. The solution is to replace the temperature switch or contactor
4. When the low voltage of the microwave drying equipment cannot be applied, it may be caused by the disconnection or poor contact of the circuit breaker. The solution is to check whether the circuit breaker connector is tightened or replace the circuit breaker
5. If the circuit breaker always trips after the microwave drying equipment is turned on, there may be three situations:
The high-voltage capacitor is broken down, resulting in a short circuit. Just replace the high-voltage capacitor
The voltage doubling rectifier diode is broken down, which requires replacing the diode
The magnetron or transformer is burnt out, and it is necessary to replace the magnetron or transformer

The above content is organized by Superb heater Company, super heater. Mainly professional production: industrial heating elements, temperature measuring elements, production equipment, accessories, and raw materials such as tubular heaters, tubular heaters, belt heaters, ceramic heaters, silicone rubber heaters, thermocouples, etc.

Welcome global industry partners to discuss cooperation!