Do you know the precautions for high-speed cutting machine of cup making machine?

Cautions for high speed cutting machine of cupmaking machine science popularization: Check whether the number of joints on the product section is consistent with the number of joints you have connected. If the hot melt adhesive coating machine is inconsistent, immediately rewind and check to prevent the inner joints from mixing with the product. According to the characteristics of semi-finished products, adjust the EPC device to ensure that the EPC photoelectricity is always on the tracking line, and use your hand to pull one end of the film to start the machine at a low speed to make the film enter the normal state. Stop pressing the stop button, and it is not allowed to touch the winding shaft with your hands during unloading to prevent your fingers from being pinched. Start the machine slowly, observe whether the slitting film meets the quality requirements, and then slowly accelerate to start slitting. When the machine is running, it is strictly prohibited to put your hands into the machine to avoid backpressure on them. Open (close) the raw material bracket to a suitable width, and place the semi-finished film roll to be cut on the bracket. When loading, the hands must be away from the film roll section. It is not allowed to operate by two people at the same time to prevent the hands from being caught by the cylinder. Return the photoelectric device to the central position, ensuring that the slider of the unwinding table remains in a suitable position in the middle of the guide rod. Thread the paper tube that meets the specifications onto the receiving shaft, pull the cut product that meets the requirements onto the paper tubes of the upper and lower receiving shafts according to the normal method, start the machine at low speed, find out the appropriate position of the paper tube on the receiving shaft, and mark it for next installation. When installing the paper tube, the hand must grasp the surface of the paper tube to prevent it from slipping and being hit by the shaft. Guide all the cut film onto the winding shaft according to the operating requirements. When the hot melt adhesive machine penetrates the film, it is not allowed to have a blade on the machine to prevent scratches. According to the requirements of the task sheet, install the cutting tool holder to the appropriate position, tighten the lower knife, and then start the machine at a low speed to cut the semi-finished product into the required specifications. Press to turn on the machine power, set the winding tension, automatic stop count of the counter, and material thickness according to the requirements on the task list, and then turn on the photoelectric device