Does Yuba come with a thermocouple? How to connect it

1. Wiring method for Yuba with thermocouple
Yuba is a common bathroom appliance that sometimes comes with a thermocouple. So, how should Yuba be wired with a thermocouple? Below will be a brief introduction for you.
2. Confirm power supply
Before wiring, first disconnect the power to ensure your safety. Use a multimeter or voltage detector to measure the voltage on the power line and ensure it is zero before proceeding with wiring operations.
3. Connect the wires
According to the wiring diagram or manual of the Yuba, find the wiring terminal marked with the thermocouple. Connect the wires of the thermocouple to the corresponding wiring terminals one by one according to the colors. Normally, the color of thermocouple wires is red, yellow, or white. When wiring, ensure that the wires are in good contact and not loose.
4. Fixed wires
After wiring is completed, use insulating tape or electrical tape to tie the wires to prevent loosening or short circuits from causing faults.
5. Restore power supply
After confirming that all wiring is securely fixed, reconnect the power supply. Turn on the switch of the bathroom heater and test whether the thermocouple is working properly. If the heat transferred by the thermocouple can be felt, it indicates successful wiring.
six
Please make sure to unplug the power plug before disassembling the bathroom heater and performing wiring operations to ensure safety.
If you are not familiar with the circuit or do not know how to wire it, please consult a professional or have an electrician perform the operation to avoid safety accidents.
Do not cut or sew wires randomly, as this may cause circuit short circuits or other malfunctions.
The above is the wiring method for Yuba with thermocouples. I hope it can be helpful to you! Remember to carefully read the manual before operation and follow the instructions to ensure correct and safe operation.