How to solve the plastic film deviation at the front knife rubber roll of the bag-making machine

1. The pressure of the bag-making machine and rubber roller is uneven, in this case, resulting in the pressure in the direction of the plastic. The solution is the standard of round rubber roller of bag-making machine; The rubber roller is completed in parallel; Then the rubber roller is horizontal. These problems will be solved one by one.
2. The photo-electricity of the plastic bag making machine may tilt, and the state must require the level of the front rubber roller. If the photoelectric frame is carried forward, the plastic film will be out, and the photoelectric plane plastic film will be brought back.
3. If the bag-making machine and punching knife are not installed, it will be warped, and the result is also a plastic film deflection, which cannot be ignored.
4. The reason for the plastic film itself, if the thickness of the plastic film on both sides is uneven, is the most likely to deviate, and it is not easy to find the reason. Bag-making machine operators should seize this opportunity in the film blowing process, or the consequences will be very serious!
5. The pressure of the bag-making machine and the horizontal sealing knife is uneven. Therefore, the pressure of the lateral sealing knife and the plastic film are on which side. It is required to check whether the pressure sealing knife is horizontal. Even at this time, there is a problem that needs to be adjusted properly.
6. The bag-making machine roll is not parallel, or it passes through a set of rubber rolls, and the parallel state must be adjusted.