How to use hydraulic punching machine and circular pipe punching machine?

How to use hydraulic punching machine and circular pipe punching machine?

In recent years, industrial development has been rapid, and there has been a continuous increase in momentum in the following two years. However, as a basic industrial production, the mechanical equipment and mold processing and manufacturing industry, especially the production and manufacturing capabilities of punching molds, cannot keep up with the requirements of industrial development. Before the application, the output power of traditional manual punching machines was very low, and it was very environmentally friendly, and the accuracy was not very good. In order to reduce the waste of human resources, fully automatic punching machines have gradually been developed to solve the waste of manpower and resources.

Hydraulic punching machine is a machine equipment mainly used for punching and punching metal composite materials, widely used in central air conditioning, electric water heaters, airports, vehicles and other pipeline processing. Today, let's talk about the common problems before applying the Weidite hydraulic punching machine and how to use it.

Common problems and operating methods before the application of hydraulic punching machines.

Before applying the hydraulic punching machine, it is necessary to first check whether there is any dirt on the punch and upper mold edge, and immediately clean them up.

Before using a hydraulic punching machine to drill holes, everyone must also add lubricating grease above the punch (a part of the left and right movement of the punch).

3. Finally, check if the cylinder is leaking.

Operation method.

1. Use screws to connect the male connector on the pump air conditioning pipe and the female connector on the special tool.

2. Select the corresponding left and right molds, first remove the molds, and then install them into the molds. When assembling the lower mold, tighten the fixing screws to a certain position before assembling the upper mold. Be sure to place it properly and then tighten the set screw before actual operation.

3. Place the workpiece properly, turn off the gasoline pump return screw, and move the joystick until the return screw is loose during work. For example, when stamping thin metal material round steel pipes, the return pad must be inserted between the return tripod and the workpiece, otherwise the workpiece will become stuck on the mold shell.

Www.superbheater.com