Installation Position Of Flange Heater

There are two installation positions for flange heating pipes. One is to install horizontally with a hole at the bottom of the side, and the other is to install vertically from top to bottom or from bottom to top.

Horizontal installation at the bottom of the side can prevent empty burning. However, when installing horizontally, the length of the heating pipe needs to be considered. Due to the influence of the force, the total support area of ​​the horizontal installation side is small and the support force is large. The main parameters of the flange should be properly considered.

When installed vertically, when the water level in the heating container of the heating pipe is lower than the heating pipe, part of the heating pipe is separated from the water level. Because the power load of the heating pipe for heating liquid is much greater than the power load of air combustion, the flange heating pipe cannot be separated from air combustion. In the case of vertical installation, if the heating pipe cannot keep all the water infiltration heating, it is recommended to leave part of the cold end (the size of the cold end is selected according to the water level) and make a liquid level controller.