Knowledge

Main line filter, in the main line, the main line filter must have minimum pressure drop and oil mist separation capability. It removes dust, moisture and oil from the pipes.

When the pressure in the air tank exceeds the allowable limit, the compressed air can be discharged. (9) Refrigerated air dryer, which refrigerates the compressed air to several degrees above zero to

A one-way valve that allows compressed air from the compressor to enter the tank and prevents the compressed air from flowing in the opposite direction when the compressor is turned off. Air storage t

Compressor, air at atmospheric pressure is compressed and fed to the pneumatic system at a higher pressure. This converts mechanical energy into air pressure energy. The electric motor provides mechan

The density of PMMA is lower than that of glass: the density of PMMA is about 1.15-1.19 g/cm, which is half that of glass (2.40-2.80 g/cm) and 43% of that of metal aluminum (a light metal). The mechan

Poly(methylmethacrylate) (PMMA for short), also known as acrylic, acrylic (English Acrylic) or plexiglass, Lucite (trade name), is often called agaric glue in Hong Kong. The advantages of transparency

Polymethyl methacrylate (poly(methyl methacrylate), referred to as PMMA), also known as acrylic, acrylic (English Acrylic) or plexiglass, Lucite (trade name), is called pressure in Taiwan, and more in

Polymethyl methacrylate (poly(methyl methacrylate), referred to as PMMA), also known as acrylic, acrylic (English Acrylic) or plexiglass, Lucite (trade name), is called pressure in Taiwan, and more in

Plexiglass is not harmful to the human body, but the use of some plexiglass daily necessities will have a certain degree of harm to the human body, but it is not very harmful, because the organic comp

Density: 1.19g/cm 3 Light transmittance: 99% Impact strength≥16kg/cm 3 Tensile strength≥61Kg/cm 3 Thermal deformation temperature≥78℃ Thermal softening temperature≥105℃. The bonding method of plexigla

Thin material cutting (2-10mm) plexiglass below 5 mm uses a 50mm focusing lens, the cutting speed is generally 0.35-0.8 m/min, the light intensity is 45-65%, and 5-10mm plexiglass generally uses 63.5

Thick material cutting (10-20mm) plexiglass above 10mm generally uses a 75mm focusing mirror, plexiglass above 25mm uses a 100mm focusing mirror, and the deepest can cut 32mm plexiglass. 10mm plexigla