Reasons and solutions for overheating of diaphragm filter press

Reasons and solutions for overheating of diaphragm filter press

In the normal operation of the diaphragm filter press, we often find that the diaphragm filter press has a hot appearance. This heat will have a certain impact on the application of the filter press, so how can we make this overheating? There are two reasons for the overheating of the diaphragm filter: one is the hydraulic system, and the other is the filter press. The hydraulic system of the filter press is closely related to temperature. It can control the hydraulic system through the heat release device of the equipment, so that the filter press can operate normally. High temperature in hydraulic stations is particularly important as it can affect the hydraulic system and prevent it from functioning properly. The filter plate is made of polypropylene material to avoid overheating treatment, slow down temperature rise, reduce the differentiation of the filter plate and yttrium oxide, as well as the application cycle of the filter plate. Reduce filter plate damage, improve productivity, and achieve higher profitability.

If the filter press overheats, it will not only have a significant impact on the operation of the staff, but also have a certain impact on the filtrate during the operation process, leading to changes in the filtrate and affecting separation. Effect, so you should pay attention to the operation. The process of overheating the filter press.

If any damage is found to the bearings of the diaphragm filter press, please replace them in a timely manner. Very strict standards are required when installing new bearings. Be careful, don't be careless.

2. Prevent strong impacts from bearings, scratches, indentations, and cracks.

During the use of the diaphragm filter press, it is important to regularly perform rust prevention treatment on the bearings and avoid dirtying water stains. Clean the surrounding area of the casing, apply lubricant and maintain it.

Errors in the control system of the filter press may cause the filter press to stop working. We all know that when the filter press is working, a control system is needed to control the hydraulic system and the range of expansion and contraction, so as to control the power generated by the hydraulic system to the filter plate and the power received by the filter plate to be transmitted to the filter. On liquids, the filtrate is directly exposed to the filter cloth through pressure, so the control system of the filter press directly affects the filtration of the filtrate.

When the control system malfunctions, or the hydraulic system cannot be controlled, or the control system cannot detect the status of the hydraulic system, the filter press naturally cannot work. Even if it is almost impossible to operate, it is still very dangerous, so it is necessary to stop the equipment work in a timely manner.

Www.superbheater.com