Several precautions for wiring and installation of titanium electric heating tubes:
Leave a message
Several precautions for wiring and installation of titanium electric heating tubes:
1. Titanium electric heating tubes are generally distributed along the length (or width) direction of the groove, evenly distributed on one side (or both sides) of the workpiece during operation, and installed against the groove wall. In the electrolytic cell, they can be placed between the electrode plate and the groove wall.
2. Titanium electric heating tubes can be installed using methods such as slot edge fixation, slot wall fixation, and pole hanging. Wiring installation plates and support components are used for drilling, and bolts are tightened.
3. When wiring, pay attention to three-phase balance and do not connect the 220V or 380V power supply incorrectly.
4. Safe grounding through leakage switch.
5. A certain distance should be maintained between the heating tubes, as they may overheat and burn out if they are tightly attached to each other.
Advantages:
1. High heating power, high thermal efficiency, not limited by slot depth;
2. Easy to use power line heating and achieve three-phase power balance;
3. Easy installation with few leads;
4. Compared with special-shaped thin tube electric heaters, the electric heating wire can be replaced
Installation precautions:
1. Electric heating tubes (heating tubes) are generally distributed along the length (or width) direction of the groove, evenly distributed on one side (or both sides) that is not touched by the workpiece during operation, and installed against the groove wall. In the electrolytic cell, they can be placed between the electrode plate and the groove wall.
2. Electric heating tubes (heating tubes) can be installed using methods such as slot edge fixation, slot wall fixation, and pole hanging. Wiring installation plates and support components are used to drill and bolts are tightened.
3. When wiring, pay attention to three-phase balance and do not connect the 220V or 380V power supply incorrectly.
4. Safe grounding through leakage switch.
5. A certain distance should be maintained between the heating tubes, as they may overheat and burn out if they are tightly attached to each other.
www.superbheater.com
