The correct steps for operating the terminal machine

The correct steps for operating the terminal machine

It is the correct step for operating the terminal machine. Only by mastering the correct steps can the machine run and work better. The first step is definitely to turn on the power switch of the terminal machine. This step is very simple, and the power indicator light will light up, indicating successful power on. The second step is often forgotten by many people, but it is also an important step. We need to check whether the machine has any abnormal sounds or other abnormal phenomena. If we find them, we need to stop working and troubleshoot before continuing to work. This is very important. The third step is to select and install knives, which requires someone who is familiar with the machine to choose the matching tools. After comparison, there is no mismatch phenomenon, and the knife can be installed. If you are not sure if it is installed well, you must use a hand cranked testing method. Step four, we need to load the material. Loading is to install the required terminals, so that the terminals can easily pass through. It is necessary to check or visually check the position of the plastic. If it is not suitable, adjust it. If it cannot be adjusted, you can refer to the manual. Generally, it is done using a hexagonal plate, loosen its screws, then tighten it to adjust to the most suitable state you think, and then tighten the screws to continue working.

Let's continue to talk about the next step. The next step is to carry out a tension test after the commissioning. I think a tension test table in the instructions should have specific methods. Just reset the tension test to zero, and then carry out the test. If the test is not within the scope of the table, then you need to ask professionals to carry out the commissioning until the standard is reached

Www.superbheater.com