The operating steps and precautions of a fully automatic terminal machine

The operating steps and precautions of a fully automatic terminal machine

1, Work steps

1. Turn on the power junction box switch, and the power indicator light will start to light up.

2. Pay attention that there is no obvious abnormal sound on the internal and external machines. If there is a shutdown phenomenon, please ask the maintenance personnel to determine whether repair is needed.

3. Carefully selected tools from fully automatic terminal machine manufacturers: When designated personnel operate, they must hold the blade support tool. After the blade comparison is correct, the blade must be measured with a hand knife after use. First, turn off the automatic terminal electromechanical power supply, press the button, and use a dedicated handle to drive the pulley automatic terminal machine. If the stroke is too large and the hand cannot move, consider whether there is too much pressure or other problems, and check and adjust. When locking the screw, please check if it needs to be loosened.

4. Attention: It is necessary to lightly tap the terminal device. The internal hexagonal wrench is used to adjust the use of the feeding plate. The terminals can be easily passed through. If the material is not delivered properly, loosen the internal hexagonal wrench of the feeder with locking screws, dynamically adjust the diameter of the screw rod to a better position, then tighten the screws and start the operation. The price of fully automatic terminal machines is also relatively suitable.

5. Tensile testing machine: Conduct a tensile test on the waste wire and see the specific operation method of the "tensile testing machine". The main reference values are as follows: reset the zero key of the tensile test to zero, test the electrical clamp of the terminal wire test, and if the tested tensile force is not within the standard range, please adjust it by the maintenance personnel until it reaches the standard value.

6.10 products are sent to IPQC for first piece confirmation, which can be inspected and mass-produced. Terminal operators must check for plastic bags and hanging defects during the production process, and conduct a terminal tension test every hour.

Price of fully automatic terminal machine

2, Introduction and precautions for fully automatic terminal machine companies

During use, if any abnormalities are found in the machine, the power should be turned off and maintenance personnel should be promptly called for maintenance and debugging.

2. Non designated personnel are not allowed to debug or disassemble machine parts.

When operating, the power supply of the fully automatic terminal machine should be cut off, and it is strictly prohibited to insert fingers or any part of the body into the punching hole to avoid accidents.

When working, if you need to leave, please turn off the power before leaving.

5. When replacing terminals, the power must be cut off first before proceeding with the replacement operation. It is strictly prohibited to replace terminals.

When operating, if it is on the end plate of the knife mold, it must be removed with scissors or needles before continuing the operation.

Www.superbheater.com