The requirements of frying machinery for wiring

Frying line function

The frying line adopts pure oil design, the heat transfer oil heat exchange heating double-layer mesh belt conveys, realizes automatic frying, the heat conduction oil heating oil temperature is constant, if the quality is good, it does not produce black oil, and the frying time can be adjusted to realize automation .

The requirements of frying machinery for wiring

1. The wiring groove of the frying machine should be smooth and free of sharp edges or corners, otherwise it needs to be protected by a protective wire.

　　2. The insulation of the internal wiring should be able to withstand the electrical stress that may occur in normal use.

　　3. When the casing is used as additional insulation for internal wiring, it should be fixed in a reliable way.

　　4. The yellow-green two-color wire can only be used for the grounding wire.

　　 5. Aluminum wire should not be used for internal wiring.

　　6. The multi-stranded wire cannot be welded where it is subjected to contact pressure, unless there is a danger of poor contact with the clamping device.

The operation process of the automatic fryer

When the fully automatic fryer is operating, first close the oil drain valve, pour the specified amount of oil into the oil tank, open the gas valve, use the ignition rod to ignite the long open flame, and adjust the corresponding air pressure according to the gas source used. Different fried foods determine the oil temperature. When the oil temperature reaches the specified value, the conveyor motor is started and the conveyor belt starts to run. The frying time is set according to the fried food, and the conveyor chain speed is adjusted accordingly. When the oil temperature rises , Put the food to be fried evenly into the input port, and the input amount accounts for 50-60% of the total area. The fried food is pulled by the pulling device to the output port and taken by the container.

www.superbheater.com