The three elements of automatic terminal machine for terminal printing are:

The three elements of automatic terminal machine for terminal printing are:

(1) The relationship between wires and terminal blocks: 1. Is the wire diameter consistent with the applicable size of the terminal block. 2. Is the length of the conductor crimping area consistent with the wire stripping size. 3. Is there any damage or breakage to the core wire at the peeling point? If there is any breakage, follow the instructions of the higher authorities. 4. Is the height of the conductor within the tolerance of the indicated value when the automatic terminal machine presses the terminal, and should be marked in the middle of the indicated value. 5. Is there any wire flying between the insulation and conductor sections. 6. Is the horn mouth on both sides? If it is on one side, it must be on the insulation side.

(2) The relationship between the terminals and connectors of the automatic terminal machine: 1. Check if there is any deformation of the locking hook and the blocking hook. 2. The exposed core wire at the front end of the conductor is too long. The exposed core wire at the front end of the conductor is too long, and when inserting into the connector, it cannot reach the hook of the connector, causing the wire to be pulled out of the connector, especially for wires with specifications of 2SQ and 3SQ, attention should be paid. 3. The shape of insulator riveting: Pay attention to the width of the protective sleeve and the insulation size. Special attention should be paid when using molds that do not match. Operations are prohibited without confirmation from relevant departments and site managers. 4. Automatic stabilizer deformation: Automatic stabilizer deformation will not fit into the connector, crack, and not match with the connector.

(3) The relationship between terminals and matching terminals: terminal fitting deformation; Confirm that the cut material is not too long, too short, or sharp. Is the front end of the terminal deformed? When inserting a connector, the deformation of the terminal can cause the corresponding matching terminal to not fit properly. Improper arrangement of automatic terminal machines or most connectors can lead to the matched terminal being pressed, causing the lock to fall off.

A machine required for wire processing, which can press the five metal heads onto the wire end and then conduct it. This type of machine has its own professional name called a terminal machine. Terminal press, also known as terminal crimping machine or terminal crimping machine. With the advancement of wire harness material enterprises towards automated production, the wire harness processing machinery and equipment market has been largely dominated by fully automatic terminal machines. Fully automatic terminal machines have won the love of many enterprises for their high efficiency, hands-free, high accuracy, and ultra quiet advantages.

The terminals produced by terminal machine manufacturers are usually designed for easier connection, allowing for stable connection of two wires without the need for soldering. However, during disassembly, it is only necessary to unplug them.

Www.superbheater.com