Vacuum dryer adsorption dryer

Vacuum dryer adsorption dryer

1. Strictly follow the ISO9001 GB standard, QS, pressure vessel inspection specifications for production to ensure long-term safe, efficient and reliable operation of the product.

2 Simple installation, simple operation and convenient maintenance.

3. Refrigeration parts and control components are all made of international high-quality brands to improve service life.

4. The heat transfer area of the heat exchanger is enlarged on the basis of the standard design, the heat transfer efficiency is better, and the stability of the dew point of the machine is guaranteed.

5 The specially designed secondary condenser makes perfect use of the outlet cold source to ensure the cooling effect of the refrigeration system of the machine, and at the same time increases the outlet temperature of the compressed air, saves energy, and avoids the loss caused by the condensation of the pipeline.

6. The high-efficiency gas-water separation device cooperates with the excellent automatic drain valve to continuously and stably discharge the condensed water out of the machine.

7. Safe and reliable protection device (the machine is equipped with high-pressure switch, low-pressure switch, water condenser safety valve, overload relay...etc. high-precision protection devices)

8 SAIFUAIR's E-CTRL series microcomputer control panel (optional accessory).

9. The product can accept various special customizations (processing capacity is greater than 143Nm/min, special specifications, materials, temperature, pressure, control methods, etc.).

Vacuum dryer adsorption dryer

The adsorption compressed air dryer uses the principle of pressure swing adsorption. When the wet air passes through the adsorbent, the moisture is adsorbed by the adsorbent to obtain dry air. Working principle: A large amount of air discharged from the air compressor flows in from the compressed air inlet pipe and enters the operating tower in the two towers through the air valve, and the moisture in it will be absorbed by the adsorbent and dried. When the air circulates to the top of the tower, all the moisture in the air is absorbed, and the dew point temperature can reach -40℃, so as to achieve the purpose of drying. The whole cycle standard takes 10 minutes, and each tower runs for 5 minutes. One tower is in the process of working (operating tower), and the other tower is in the regeneration state (non-operating tower). The regeneration time is 4.5 minutes, and the continuous pressure time is 0.5 minutes. During the regeneration process, a part of the dry air in the operating tower enters the non-operating tower through the regeneration air volume control valve, and the water in the tower is brought to the atmosphere through the muffler.

www.superbheater.com