What are the action programs of injection molding machines?

Injection molding machine operations include the following:

1. Preparation: Check the machine for proper function, clean the mold and machine surface, and check the raw material storage and supply.

2. Setting the Injection Molding Machine Parameters: Set parameters such as injection pressure, injection speed, and hold time according to product requirements.

3. Adding Material: Place the raw material into the hopper and ensure it is adequately filled.

4. Starting the Machine: Start the injection molding machine and preheat it to the desired temperature.

5. Mold Adjustment: Install the appropriate mold and adjust the mold opening and closing gap, injection position, and other parameters.

6. Injection Molding Process: While the machine is running, inject molten plastic into the mold. During injection molding, parameters such as injection speed, injection pressure, and injection time must be carefully controlled.

7. Holding Pressure: After injection is complete, hold pressure is maintained for a period of time to ensure adequate filling and molding of the product.

8. Shot Recovery: Shut down the injection molding machine, remove the molded product, and proceed to further processing and packaging.

9. Cleaning and Maintenance: After each operation, clean and maintain the injection molding machine to keep it in good condition.

10. Troubleshooting: If a fault occurs during operation, it must be promptly corrected and repaired to ensure the normal operation of the injection molding machine.

The above is a general procedure for injection molding machine operation. Specific operation steps may vary depending on factors such as machine model, product requirements, and production process.