What are the details to pay attention to when replacing the ring mold for the granulator

The ring mold of the granulator is the core component of the equipment and is also a wearable component. Therefore, replacing the ring mold becomes a necessary matter during the operation of the granulator. When replacing the ring mold when using the granulator, we need to pay attention to some details during the process of replacing the ring mold.
First of all, during the trial run of a new ring mold, it is necessary to feed oily materials first, ensure that all mold holes (over 90%) are discharged, and then add materials with high friction to grind the mold holes.
Secondly, when a new ring mold is put into use, the speed of the feeder should be slowly adjusted. The feeding speed cannot be increased until the ammeter pointer has stabilized. If the ring mold is blocked, it is necessary to first clean up the materials in the pressing room, and then restart the granulation host. At this time, it is not possible to start at the originally set feeding speed, and use a lower feeding speed to put it into operation. "Because the material in the annular mold hole of the granulator is tightly plugged into the hole after cooling, additional pressure must be applied to allow the material to pass through the mold hole. Subsequently, the feed rate and steam rate can be increased according to the ammeter situation.". Experienced operators can improve the granulator to optimal production capacity within minutes.
Finally, I would like to remind everyone not to be anxious when using a new ring mold. It is very necessary to let the new ring mold heat up before obtaining the optimal production capacity.

The above content is organized by Superb heater Company, super heater. Mainly professional production: industrial heating elements, temperature measuring elements, production equipment, accessories, and raw materials such as tubular heaters, tubular heaters, belt heaters, ceramic heaters, silicone rubber heaters, thermocouples, etc.

Welcome global industry partners to discuss cooperation!