What are the precautions for operating a terminal machine?

What are the precautions for operating a terminal machine?

The automatic terminal machine is composed of an oil tank, a power mechanism, a directional valve, a pressure relief valve, and a pump oil mechanism. The pump oil mechanism of the terminal machine is composed of an oil pump body, high and low pressure oil outlet holes, an eccentric shaft, an eccentric bearing, a driven gear, a pair of high-pressure oil pumps, and a low-pressure oil pump.

Terminal machines can be used for pressing precision instruments, electronics, bearings, shaft sleeves, water pumps, turbochargers, transmissions, gears, etc., as well as for assembling automotive shock absorbers, precision bearings, shaft sleeves, automotive components, water pumps, turbochargers, transmissions, gears, automotive chassis components, rear axles, subframe bushings, and other machinery.

Automatic terminal machines are relatively large machines. In daily work, only by following the correct operating steps can safety accidents or damage to the machine be prevented. Terminal machine operators must undergo professional technical training and pass the training before they can start working. So what are the precautions for operating the terminal machine?

Before operating the terminal machine, first confirm whether the power and air supply of the machine are connected properly, and whether all parts of the machine are in the normal position. If they are not in the normal position, manual adjustment is required to restore them to the normal position. Before running the terminal machine, do not press the "start" button directly. You need to press the reset button first to reset. If the reset button flashes directly at this time, press the "Step" button first, then press the "Reset" button, and the flashing will disappear. After resetting the terminal machine, press the "Step" button, then press the "Start" button to gradually run the device for one cycle and check its operating status. If there are any abnormalities during the operation of the equipment, immediately cut off the power supply and report to the maintenance personnel for maintenance and debugging in a timely manner. Non maintenance personnel are prohibited from debugging or dismantling mechanical components without permission.

During the operation of the terminal machine, fingers or any part of the body must not enter the moving parts or squeeze the mold. If necessary, stop the machine and disconnect the power switch before operation. When two or more people approach the equipment at the same time, one person should be responsible for unified command and cooperate with each other during operation. When replacing wires, terminal machines, molds, or cleaning, disconnect the power supply before proceeding with the replacement operation. It is strictly prohibited to replace equipment during operation. If the wire is blocked or the terminal is stuck, first disconnect the power supply of the terminal machine, and then use tweezers and other tools to remove it. It is strictly prohibited to reach into the machine or mold.

Www.superbheater.com