Air conditioning insulated PTC electric heater

Air conditioning insulated PTC electric heater

Cost saving and long lifespan.

Due to the fact that the heater is not only made of special materials, but also internally connected with integrated chips, it can control its own heating in real time, avoiding damage caused by excessive temperature to the heater, thus giving it a much longer lifespan than other heaters.

2. Safe, green and environmentally friendly.

The design of the heater body has a heating temperature of multiple levels below 200 degrees Celsius. In any case, the body does not turn red and has a protective isolation layer. In any application, insulation materials such as asbestos are not required for cooling treatment. It can be used with confidence and there is no problem of scalding or causing fire to the human body.

3. Save electricity.

Compared to electric heating tubes and resistance wire heating products, this product adjusts its thermal power output based on the characteristics of the material itself and changes in environmental temperature. Therefore, it can optimize and control the electrical energy consumption of the heater to the minimum. At the same time, materials with high heating efficiency also greatly improve the utilization efficiency of electrical energy.

·Rapid heating, automatic temperature control in case of fan failure, and long service life

·Wide voltage range, can be designed as needed between 12V-380V

·Convenient design, can be designed from low to high power, and the appearance can also be designed according to requirements

·Non combustible, safe and reliable, no redness or open flames when PTC heats up

In small and medium-sized power heating applications, PTC heaters have advantages that traditional heating components cannot match, such as constant temperature heating, no open flame, high heat conversion rate, minimal influence from power supply voltage, and long natural life. Their application in electric heating appliances is increasingly favored by research and development engineers.

Precautions for use

(1) PTC heating pads have the characteristic of automatic constant temperature, and their own heating temperature also has a maximum value, which effectively prevents damage to themselves and other components due to excessive heating in electrical equipment.

(2) When the PTC heating plate is used to heat liquids (such as water), the PTC heating plate will not be damaged after the liquid is dried.

(3) If the PTC heating plate is used to heat cold air, it will not be damaged when there is no air supply.

(5) Long service life, used in normal environments, with a lifespan of over 10 years.

(6) Reliable operation, utilizing the internal characteristics of PTC heating pads to control temperature, never exceeding temperature.

(7) The working voltage is very wide: when the working voltage changes twice, the change in surface temperature is very small.

(9) When multiple PTC heating pads are used together, they should be connected in parallel and cannot be connected in series.

(10) Different heat dissipation conditions result in significant differences in the heating power of PTC heating plates.

(11) The heating power increases from high to low after being powered on, and finally stabilizes. The stable power is related to the usage conditions. For the same PTC heater, if the usage conditions are different, the power may differ by several times. The faster the heat dissipation, the greater the stable power; The higher the surface temperature of PTC, the higher the power.

(12) The surface temperature of PTC heating elements is controlled by PTC itself or by disconnecting the circuit, but the surface temperature cannot be controlled by adjusting the voltage

www.superbheater.com