Common faults and troubleshooting methods of extruders

The common faults and troubleshooting methods of extruders are as follows:

1, The temperature rise of the main motor bearings is too high:

1. Cause of occurrence:

(1) Poor lubrication of bearings.

(2) The bearings are severely worn.

2. Cause of occurrence:

(1) Check and add lubricant. Check the motor bearings and replace them if necessary.

2, Unstable head pressure:

1. Cause of occurrence:

(1) The main motor speed is uneven.

(2) The feeding motor speed is uneven, and the feeding amount fluctuates.

2. Handling method:

(1) Check the main motor control system and bearings.

(2) Check the feeding system motor and control system.

 

3, Low lubricating oil pressure:

1. Cause of occurrence:

(1) The pressure setting of the pressure regulating valve in the lubricating oil system is too low.

(2) Oil pump malfunction or blocked suction pipe.

2. Handling method:

(1) Check and adjust the pressure regulating valve of the lubricating oil system.

(2) Check the oil pump and suction pipe.

4, Slow or ineffective automatic screen changing device for sheet production:

1. Cause of occurrence:

(1) Low air pressure or oil pressure.

(2) The cylinder (or hydraulic station) is leaking air (or oil).

2. Handling method:

(1) Check the power system of the screen changing device.

(2) Check the sealing condition of the cylinder or hydraulic cylinder.

5, Safety pin or safety key cut off:

1. Cause of occurrence:

(1) Excessive torque in the extrusion system

(2) The connection between the main motor and input bearing is not concentric

2. Handling method:

(1) Check if any metal or other objects have entered the squeezing system and stuck the screw. At the beginning, check if the preheating heating time or heating value meets the requirements.

(2) Adjusting the main motor

 

6, Sudden decrease in extrusion volume:

1. Cause of occurrence:

(1) The feeding system has malfunctioned or there is no material in the hopper.

(2) The squeezing system enters the hard screw, preventing the material from passing through.

2. Handling method:

(1) Check the material level of the feeding system or hopper.

(2) Check and clean the extrusion system.

 

7, Unstable host current:

1. Production reasons:

(1) Uneven feeding.

(2) The main motor bearings are damaged or poorly lubricated.

(3) A certain section of the heater is malfunctioning and not heating.

(4) The screw adjustment pad is incorrect, or the phase is incorrect, resulting in component interference.

2. Handling method:

(1) Check the feeder and troubleshoot.

(2) Repair the main motor and replace the bearings if necessary.

(3) Check if each heater is working properly and replace it if necessary.

(4) Check the adjustment pad and pull out the screw to check for any interference.

8, The main motor cannot start:

1. Cause of occurrence:

(1) There is an error in the driving program.

(2) There is an issue with the main motor thread, is the fuse burnt out.

(3) The interlocking device related to the main motor works

2. Handling method:

(1) Check the program and restart in the correct driving sequence.

(2) Check the main motor circuit.

(3) Check if the lubricating oil pump is started and check the status of the interlocking device related to the main motor. The oil pump does not turn on, and the motor cannot be turned on.

(4) The induction power of the frequency converter is not fully discharged. Turn off the main power and wait for 5 minutes before starting.