How to adjust the pressure of domestic fully automatic terminal machines

How to adjust the pressure of domestic fully automatic terminal machines

The production capacity of terminal machines is commonly used with a current of 220 volts and some compressed gas, so the corresponding power switch and air pressure switch must be turned on before starting production.

The fully automatic terminal machine effectively reduces the large span cooperation of various mechanisms in traditional operation processes, reduces mechanical transmission running in, and greatly reduces unstable factors. The simplification of the structure significantly reduces the subsequent maintenance costs. The fully automatic terminal machine breaks the traditional meaning of automatic and mobile operation process layout, integrating cutting, peeling, tapping, and twisting into a straight line. The fully automatic terminal machine reduces the production time of a single electronic wire due to the integration of various operating mechanisms in a straight line, and the production capacity is astonishingly several times higher than traditional models.

The power cord of the terminal machine should be connected to a ground wire, otherwise static electricity can harm the workers. Before starting the terminal machine, it should be lubricated with lubricating oil. Then check and tighten the loose screws and corresponding equipment, and then drain the moisture in the air circuit.

The pressure of the fully automatic terminal machine can be adjusted: if the pressure of the terminal machine is too high, it may damage the terminals of the wires. If the pressure is too low, the terminals will slide off the wire conductors. Adjustment method: Loosen the three screws in front of the slider, slide the adjustment screw on the head of the slider clockwise to increase pressure, and then lock the three screws in front of the slider. Conversely, it will decrease its pressure.

If you find that after the wire of the terminal machine moves to a certain position, the stopping position of each wire is unstable, it indicates that the transmission speed of the track of the terminal machine is too fast. You can adjust the transmission speed of the track by loosening the locking nut of the speed valve on the cylinder, turning the speed control valve stem clockwise to reduce the speed, and turning it counterclockwise to increase the speed. After adjusting the speed to the appropriate level, you need to tighten the locking nut.

Www.superbheater.com