Knowledge

It is a kind of conversion of electromagnetic energy into energy to heat raw materials that need to be heated. During the work of the heating tube, the ultra-low temperature hydrodynamic substances en

The relative path of the design scheme using the basic principles of hydrodynamics and thermodynamics of the air electric heater removes the high-temperature thermal kinetic energy caused by the work

The key locations where the exposure appears are the seal between the plate and the plate, the position of the two leak seal grooves of the plate and the top of the plate and the inside of the clampin

When the temperature information of the electric air heater shows abnormality, people must first check whether the gas power switch has been covered, and then check whether the control circuit is inta

The three methods all use a steel plate to support the electric heating tube in the structure to reduce the vibration of the electric heating tube when the fan is stopped. The over-temperature control

The three types of high-temperature heating, medium-temperature heating and low-temperature heating are mainly used for heating through the air in the air duct; the three heating methods have similari

Check the switching power supply of the air heater to ensure that it is caused by a problem in the route. Is the three-phase power all normal or broken? If the phase is broken, immediately find an ele

In addition to over-temperature protection in the operation, inter-transport equipment is also installed between the fan and the heater to ensure that the electric heater starts. After the fan is star

The air duct heater is an electric heater device that heats the pipeline or the material therein. It is composed of a single-chip microcomputer design and a temperature sensor to form a temperature co

The power of the electric air heater is determined based on the calculation of the air volume and temperature rise. Under the premise that the air volume and temperature rise have met the demand, it i

The air duct heater is composed of itself and an automatic control system. The hot components use stainless steel pipes for maintenance waterproof casing, high temperature resistor alloy wire, crystal

Thermal insulation should be added to the appearance of pipeline electric heaters. When using the air electric heater, only the outlet pipe of the electric heater is insulated, and no insulation treat