Silicone rubber heating belt and how to maintain it in daily life

1. Before use, you must pay attention to whether the power supply voltage used is consistent. The electric vehicle battery heater uses the heat energy generated by the auxiliary heater to heat the battery pack, which will not consume the battery power, so it will not affect the power and cruising range of the electric vehicle. At the same time, it can also ensure the heat required by the air conditioning system. The vehicle controller distributes heat by controlling the opening of each electronic control valve, and the control method is simple. The lithium battery heater has basic functions such as heating, constant temperature, and temperature control. The livestock water tank heater is specifically a kind of livestock water tank heating system. When using, the power socket ground wire must be grounded according to regulations.

2. When using electricity, do not touch the left side of the box with your hands, or wipe it with a wet cloth, rinse with water, and cut off the power supply.

3. The power cord should not be wrapped around metal objects, and should not be set in high temperature or humid places to prevent rubber aging and leakage.

4. Do not overcrowd the items in the box, and leave space for natural convection of air quality so that the humid environment air system can escape faster on the top of the wind.

5. Check the silver contacts of the thermostat regularly to see if they are hairy or uneven. If so, use fine gauze to sand the contacts flat before use, and wipe them clean with a clean cloth to ensure good contact (note that the power supply must be turned off). Do not hit the metal pipes of the indoor thermostat to avoid affecting the sensitivity. 6. Do not put flammable materials in a drying oven without explosion-proof safety devices. 2. Do not put explosive, flammable, or volatile items in the drying oven to avoid explosion. 2. The average load of the sample rack should not exceed 15 kg. 3. Do not place items on the rack between the sample chamber and the heating chamber to avoid affecting heat exchange. 4. Before use, be sure to check whether the nickel wire is overlapped or short-circuited.

5. The heating lamp is not on. The reasons are generally three: (1) The bulb is broken: (
... Prevent sharp objects from scratching the equipment.

5. Please do not disassemble the electrical components and other parts of the equipment at will to avoid damaging the electrical control circuit, causing artificial failure of the equipment and affecting its performance.

Silicone rubber performance heater, silicone rubber for heater, heating tube

(VI) When storing and using the equipment, there must be no flammable, explosive or corrosive items around.