The detailed structure of the side edge of the punch press of the blister equipment

The punch side edge is a punch that cuts out the feeding positioning gap on the side of the strip (belt, roll) material. The side pressure plate is a plate-like part that applies pressure to one side of the strip (belt, coil) material through a spring, so that the other side is close to the guide plate (see introduction). The ejector bar is a rod-shaped part that directly or indirectly ejects the process (sequence) piece or sequence material. The top plate is a plate-like part that moves in the die or module, and directly or indirectly ejects the process (sequence) or waste (see introduction) by upward movement. Ring gear (see introduction). Limit sleeves are tubular parts used to limit the minimum closed height of the die (see introduction). The limit post is a cylindrical piece that limits the minimum closed height of the die. Dowel pin (plate), (see introduction).