The installation method of the single head electric heating tube for the mold is very important, and we need to install it according to the following three requirements:

The installation method of the single head electric heating tube for the mold is very important, and we need to install it according to the following three requirements:

1. The one-sided gap between the mold hole and the surface of the single head electric heating tube of the mold shall not exceed 0.05mm. If the gap is too large, it will affect the heat conduction of the single head electric heating tube of the mold.

2. When installing the single head electric heating tube of the mold, it is necessary to clean the mold holes to avoid residue left by carbon deposition after the heating tube was heated earlier. This residue will affect the installation and thermal conductivity of the single head electric heating tube in the mold.

3. When installing the single head electric heating tube of the mold, the heating area cannot leak out of the mold, because the part that leaks out of the mold is exposed to the air, and the heat conduction is relatively slow. When the heat transfer is not timely, the surface temperature of the single head electric heating tube of the mold is too high, which will burn out the single head electric heating tube of the mold.

When installing the single head electric heating tube of the mold, it should not be too deep into the hole, so that the seal and wire of the single head electric heating tube of the mold may be burned out due to high temperature.

4. The single head electric heating tube of the mold should be firmly fixed. Prefabricated screw holes can be installed to support the heating tube, and a fixed stopper can be added to fix the electric heating tube, ensuring that the single head electric heating tube of the mold does not shake to avoid the adverse consequences mentioned in the previous article.

5. The single head electric heating tube of the mold should be used as much as possible in an environment with air circulation, which is conducive to the rapid conduction of temperature on the surface of the tube.

4, Control temperature

When using the single head electric heating tube of the mold, temperature control monitoring must be added to ensure that the temperature control cannot exceed the maximum temperature resistance limit that the single head electric heating tube of the mold can withstand.

The above content is the answer to the design, material selection, usage conditions, installation and other related issues of the single head electric heating tube for molds. If you want the single head electric heating tube for molds to not be easily damaged, you must choose according to the above points, so that the service life of the single head electric heating tube for molds can be longer.

Www.superbheater.com