What are the practical protection methods for heating pipes

What are the practical protection methods for heating pipes

 

In order to prevent corrosion and rust of the heating tube, chemical treatment is required, that is, the surface treatment of the heating tube. Heating tubes for different purposes are in different environments, surface treatments are also different, and chemical treatment methods provided are also different. How to choose suitable heating tubes in different liquids is what we need to learn and understand.

Heating pipes for heating liquid water can also be divided into large heating pipes for boiler applications and small heating pipes for general industrial use according to their applications. In order to prevent rust and corrosion, the most common thing we use is to process the surface of the heating tube with copper. There are also corrosion-resistant heating pipes selected for their materials. Customers can directly contact by phone when they encounter specific situations. We recommend the best method to you from a professional perspective.

Pipe diameter: 8 mm R≥15 center distance=30 mm

Pipe diameter: 10 mm R≥20 center distance=40 mm

Pipe diameter: 12 mm R≥25 center distance=50 mm

Pipe diameter: 14 mm R≥30 center distance=60 mm

Pipe diameter: 16 mm R≥35 center distance=70 mm

Pipe diameter: 18 mm R≥40 center distance=80 mm

Pipe diameter: 20 mm R≥45 center distance=90 mm

Pipe diameter: 22 mm R≥50 center distance=100mm

Pipe diameter: 24 mm R≥55 center distance=110mm

Pipe diameter: 25 mm R≥60 center distance=120mm

The above is marked when the heating tube diameter is 8mm, its tube diameter radian is 15, the center distance of the U-shaped heating tube is 30mm, when the heating tube diameter is 10mm, its tube diameter radian is 20, then The center distance of the U-shaped heating tube is 40mm, and so on.

What is the emergency if the electric stove wire is broken?

 

1. Make sure that the contact is good. You can do this: first polish the joint of the electric furnace wire clean, and then wrap the lead (usually copper wire) on the joint, and wind it a few more times.

2. If the wire diameter is less than 2.5mm, it is recommended to replace it with a new one, otherwise A402 electrode can be used for welding.

3. The length of the electric furnace wire is different when it is subjected to different voltages. The length of the coil can be shortened, which is also beneficial to the concentration of heat; the collision of the coil and the coil is the same as the above, and it is easy to fuse at high temperature.

 

4. The electric stove wire is broken, it is best to replace it with a new one. For emergency use, screws can be used to press and connect the broken head tightly to prevent poor contact and burn again when used again.

www.superbheater.com