How to use an electric kettle? What is the problem of an electric kettle not boiling water?

An electric kettle can boil hot water for people in the shortest possible time, which is currently the most common small household appliance product seen by people. However, how to use an electric kettle? When using an electric kettle, there is a problem of not being able to boil water, which affects the normal use of the kettle. What is the problem of not being able to boil water in an electric kettle?

1, How to use an electric kettle?

1. Carefully read and keep the product manual. When using an electric kettle to boil water for the first time, it is necessary to first clean the inner container of the kettle with hot water; Afterwards, add an appropriate amount of water to the kettle. The amount of water added to the electric kettle should not be too little, but not too much. Excessive water can easily overflow during the boiling process.

2. Add an appropriate amount of water to the hot pot and connect the pot body and base to ensure the stability of the hot pot placement. After connecting the heating base and the kettle body, plug in the power cord and press the start switch of the kettle. At this time, the electric kettle will automatically start boiling water. After the water is boiled, the hot water kettle will automatically shut off, and it will immediately enter the insulation state.

3. When adding water, be careful not to lower it below the lower water level line, but also not to exceed the upper water level line. Close the lid tightly and press the button again. The water will automatically close when it boils. Many electric kettles have a double-layer design, which can achieve thermal insulation and prevent scalding, thus avoiding scalding situations.

4. When there is no water in the pot, when adding water, when not in use, when cleaning or moving the kettle, or when there is a problem with the kettle, the power cannot be turned on. It is strictly prohibited to immerse electric kettles, power cords, or power cord bases in water or other liquids to avoid any danger. Do not use other external power cords without professional testing.

2, What is the problem of an electric kettle not boiling water?

1. It may be caused by the thick scale on the surface of the electric heating tube, which is not easy to conduct heat and causes the internal temperature of the heater to be high but cannot boil water. This not only increases power consumption, but also directly affects the service life of the electric heating kettle. So after using the electric kettle for a period of time, it is necessary to promptly remove the excessive scale on the electric heating tube, which may cause the problem of water not boiling.

2. It may also be caused by damage to the temperature control switch installed at the bottom or near the bottom side of the electric kettle. When disassembling the kettle, it can be seen that it is cylindrical in shape, with one fixed screw installation hole on each side and two connecting wires on top. After disassembling, the words 110 ℃ or 105 ℃ can be seen on the surface. This type of temperature control switch is sold in general home appliance accessory stores or repair points. When purchasing, it must be the same as before and cannot be higher or lower than the original temperature value, otherwise the water will not jump even when it is not turned on or when it is turned on.

3. Common reasons include low power supply voltage, poor contact of indoor power lines or plug sockets, which should be eliminated. If the contact between the base and the power plug socket of the pot body is severely poor, the contact piece and contact oxide layer and dirt of the plug socket can be removed first, and then its shape can be corrected to make the two contact tightly and well.

How to use an electric kettle? It is recommended to refer to the manual before using an electric kettle. Generally, the manual provides instructions on how to use an electric kettle. What is the problem of an electric kettle not boiling water? When the electric kettle cannot boil water, it must be solved immediately to restore normal operation.