Precautions for use of heat-shrinkable film packaging machine

First, the power of the heat-shrinkable film packaging machine is relatively large. In daily use, it should be noted that when wiring, please ensure that the power supply must be greater than the nominal power of the shrinking machine, otherwise it is easy to burn the line or machine.
Second, the heat-shrinkable film packaging machine must be reliably grounded, and a bottom line should be drawn from the ground painted with insulating paint to protect personal safety.
Third, Shenzhen Kailuwei Machinery Equipment Co., Ltd. guarantees that each heat-shrinkable packaging machine sold has a cable connecting to the power supply when it leaves the factory, and its end lead part has the identification symbol of the power supply. Please also use it correctly. If you encounter any problem that you do not understand during the use, it is recommended to call our company or read the equipment manual delivered by the machine. All illegal operations may cause the machine to burn out or electric shock.
Fourth, when the specified voltage of the machine is three-phase 380V power supply, the zero line must be connected at the same time, that is, the standard three-phase four-wire system. Otherwise, the machine can not work normally, and it is very easy to burn the internal electrical components.
Fifth, the heat shrinking machine must be installed horizontally, otherwise the service life of the electric heating tube will be shortened; For the machine driven by mesh belt, its inclined installation will cause the conveyor belt to deviate from the center and greatly reduce its service life.
Sixth, when the machine has been used continuously for more than three months, the high temperature resistant line of the contraction chamber should be inspected and replaced as appropriate based on its aging degree.
Seventh, when the machine is working, the palm and other parts of the operator are not allowed to contact with the running parts of the machine, especially the temperature inside the contraction chamber is very high, which is easy to burn.
Eighth, after the completion of packaging work, turn off the heating switch of the heat shrinking machine first, let the conveyor motor and fan motor continue to run for about 10 minutes, and then cut off the entire power supply.